Melodee

Firmware for the M-VAVE FM-1

Install Melodee

Synths, sequencing and effects for the FM-1, installed over USB from this page.

  1. Connect the FM-1

    Plug it straight into this computer, without a hub, and switch it on. Close other music apps and editor tabs. When the browser asks to use MIDI devices, choose Allow.

  2. Install

    Back up your sounds first: Settings, then Backup, in the editor.

    Find your FM-1 first.

If an installation stopped

Nothing is lost. Until an installation finishes, the FM-1 starts in update mode: its screen shows UPDATING, or stays dark. That holds even after switching it off.

Connect it, open this page and press Find FM-1. The page offers to resume, and continues from the start of the write.

TransitFM1

·

Report a problem

If the FM-1 crashed, don't switch it off: the crash record survives a restart, not a power cycle. Connect it and read the record, then send it with what you were doing.

If the FM-1 won't start

With m-bootloader: switch off, hold PLAY and switch on for its recovery menu, or hold REC for USB download mode.

Without it, the FM-1's USB recovery route can put a firmware back from a computer: felucca-bsp recovery tools

Before you start

m-bootloader is written last, after one more restart. Keep the power on until the page says Done.

Keep this tab open and in front. Don't unplug the FM-1.

  1. Prepare
  2. Write
  3. Restart
  4. Setup
  5. m-bootloader
Details